Had similar problem on 364 which uses same control unit. On this one the draft control spool valve attachment point for the chain broke. The chain was in intact but several links had a lot of wear.
We just replace a the chain with a hardware store chain of similar length and link size. make sure you replace the protective sleeve over the chain to protect it from wear. You may want to inspect the draft control spool valve chain attachment point for wear or cracks. If you have removed the unit it is pretty much in pieces you may want to replace the o rings and seals to ensure smooth operation. For the 364 there was a couple part numbers for rebuild kit with the seals and orings.
Also you may want to consider replacing the gasket on the bottom plate to prevent the unit from leaking hydro. fluid into the transmission housing if you have to pull the hydro unit.Thats a hard leak to fix once it back to assembled again.The factory manual has excellent descriptions on how the control functions and service/troubleshooting info.
good luck/ be patient /and extra clean and you should ok.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.