Jim is spot on about the graphite-block bearing. I know I encountered one on my SuperC and, from what I read about the two kinds and the number of posts on here, it may have been the more common bearing.
IH listed the more conventional bearing and its carrier as optional with the Hydra-Creeper unit. For that unit to operate required blocking down the clutch pedal (other optional parts accomplished that) so that a hydraulic motor could backfeed into the transmission through the brake shafts. It may have been a fine bearing for day-to-day use moving a tractor around, but the graphite-block bearing would not have held up under that kind of use.
The carrier is still available from Case IH. It comes dear, but my view on dealer parts of that sort is that it can't be cheap to supply and stock unique parts such as that for 60-year-old tractors. The bearing can be got for less elsewhere, but for a project like that, I'd probably pay IH's price for the bearing as part of the same purchase. The separate profit on the bearing is the kind of thing that encourages/allows the company and the dealers to keep supplying them.
Yours is pretty much shot. If it's any comfort, I had to replace a perfectly serviceable one when I overhauled mine. From the time the graphite bearings are new, the clutch fingers find a home and wear into the face of the graphite. Works well as long as it's all worn in. Removing and putting back as I did, the line up was off from where it had been worn in over the years and the fingers ripped chunks out of the edge of the ggraphite, enough so that I had to resplit and replace it with the carrier and separate bearing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.