Farmall & IHC Tractors Discussion Board |
Re: B Starting problem and a tranny leak
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on July 06, 2000 at 18:53:53 from (208.51.245.19):
In Reply to: B Starting problem and a tranny leak posted by Matt Steele on July 06, 2000 at 13:17:51:
Matt, I can see only three non-tapped holes around the gearbox, one in front, which is in the clutch housing tube, and one on each side, which are in the axle (differential shaft) casting. These are drain holes to allow condensed moisture to drain out, if there is gear oil leaking from there, it is probably a leaky axle seal or transmission input shaft seal. You will need to remove the axle to replace the axle seal, and split the tractor if it is the input shaft seal.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|