A weak or broken plunger spring or a sticking plunger may also contribute to this problem. This problem is not too unusual on Delco starters. When the solenoid is energized the plunger is drawn into the solenoid and causes the switch under the cap to close. When power is no longer applied to the S terminal the spring moves the lever and in turn withdraws the starter drive from the ring gear. It also allows the switch to open and the starter motor stops turning. The load on the drive gear as it meshes with the ring gear keeps the drive from sliding back on the armature shaft. If there is a problem with the stop collar on the armature the drive may engage too far and there is not enough movement to allow the switch to open.
If the starter is removed from the tractor the load is no longer there and the starter will work like it should. Likewise it would most likely not show any problems if the engine were started. In that case as the engine started the load on the drive would be released and the solenoid plunger spring would be able to retract the drive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.