Posted by Eric Kaltenbach on December 22, 2010 at 18:00:36 from (65.215.14.1):
I have a IH 544 with a C200 gas motor that was just rebuilt. I am having problems getting it to run. I might have a timing issue but when I tore the engine down to have it rebuilt I noticed an unusual amount of pitting and carbon on the manifold and head. I was told the manifold might be warped and sucking to much air to allow my tractor to run. I have a few questions here. The first one here is has any one on this forum bought the replacement manifold from the store here? My manifold exhaust on the side the other exhaust off center. Would this work on my tractor. Where could I find a intake/exhaust manifold either new or used that would work on my tractor? Just to clarify the first question. Has anyone bought the manifold from the store here at Yesterday"s Tractor and used it on the C200 gas motor for the IH 544 and if so did it work out or was modifications need to be made? Is there any silicon that is heat resistant that can be used on the manifold and head to help make a good seal other than the gasket? I am much appreciative and thankful to all who can help me here.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.