Posted by tempola on December 20, 2010 at 04:42:05 from (75.120.185.15):
In Reply to: Changing Rear Tires posted by Matt Weltz on December 20, 2010 at 04:22:37:
sometimes you can break the bead by placing the tire and rim under a tractor draw bar, or large truck, and place the foot of a lift all farm jack on the tire next to the rim. jack it up to place some pressure on it. and get out your sledge hammer.
if it breaks loose, flip over the rim and repeat.
More often than not, the inside rim has rusted, firmly holding the tire in place. if this is the case, you may not be able to save the tubes. a very stubborn tire will have to be cut open enough, (I use a chain saw) to get to the inner bead. I then cut the inner beads open from the inside with a die grinder, through all the wires. once the bead splits open, the tire will practically fall off.
once the tire is off, grind the old rust off. if you dont, the new tire will not want to come all the way out against the outer flanges. I usually use lots of dish soap and slick it up.
I would use new tubes. it's just too much work to have to redo the job!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
