Hi John T: Your answer is that it takes more voltage to jump a gap when the air pressure goes up. OK? Don't ask for formula etc.. It has been about 46 or 47 years ago when I worked in a Research & Development Lab at Collins Radio in Cedar Rapids IA. One job I was on for a few months was to evaluate a new antenna coupler for the then front line F-4 Phantom fighter. I put it in a large pressure chamber and tested it at various pressure settings.. Sea level to 50,000 feet in 5 & 10K steps. Amazing how much RF energy was lost into space with less air pressure. I should have also run it in the dark and taken pictures of electric "sparks" all over the unit. Same concept as your question: Voltage needed with change in air pressure. More air pressure needs more voltage. Use the top fuel quarter mile engine voltage needed as a referance.. Duration(time) of the spark plays a big part too in amount of electrial power needed. I quit Collins after just 6 years since I liked flying more and it payed better.. even though Collins R&D lab was a Great job. ag. ret.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
