I will take issue with the spark at idle is harder to establish. There is compression at idle not vacuum . If you are at high RPM and then back off the throttle the engine very often does back fire proving your statement is correct about poor ionization in a vacuum. My field of working in power stations with high voltage switching equipment that has various ways for arc quenching has used that one.
The poor idle issues for most old tractors is with the magneto systems. A mag fires hotter(more voltage) as the rpm goes up. The only way to start with a mag is the impulse unit that speeds up the armature on the mag to get a spark hot enough for starting and low rpm. In the parades just about all the time one tractor starts missing with a fouled plug.
Also you are correct in your statement that dwell does not change , but I respectfully cannot agree that the difference of 600 to 2000 rpm take the same current.
(ie) dwell for chev 350 v8 is 28-32 degrees. That is with a gap of 17 thousand. If you have it at 30 degrees then open time is 15 degrees. Dwell angle for four cylinders are around to 60 degrees then the open is 30 degrees. If the points gap is smaller the dwell angle is higher as in our old tractors.
anyway I am of to pick up a 300U, good metal and tires and is supposed to run well. The wife said she would drive it in the parade of power if we get it fixed up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.