Chris, I have seen quite a few C113's cracked in that area, and to the same extent. I have also see successful re-use of those cracked blocks and I have seen failures.
So, if you decide to give it a try, here are things to consider. These engines are thermo siphon. No pressure from the cooling system. These engines are low compression and low RPM. I believe it was Gene's comment that that area is low stress, and I agree. Also, these are sleeved engines, another plus.
The absolute best route is a good used block. However, if that doesn't work out, you can certainly try to use this one. The only potential waste of $$$ is the head gasket and your time.
Interesting thought. I have taken heads off of C113 engines to do valve jobs and found the block cracked in the same area as yours. Aside from needing a valve job, the engines ran fine, ie. no oil in coolant, and no coolant in oil. If I hadn't pulled the head, I would never have know it was cracked. Long story short: you have to decide, because "your mileage may vary"! :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
