Posted by Dave H (MI) on December 08, 2010 at 19:06:10 from (205.188.116.73):
I am reassembling a completely torn down and repainted Cub. Been into the service and parts manuals and cannot seem to come up with an answer to this one.
The fan spindle slides down into a fork cast into the block. A nut on the engine side of the fork tightens it in place and there is a place on the spindle on the other side of the fork by the generator pulley that is flattened on both sides so you can put a wrench on it to tighten the nut. There is a large flat washer. I have it on the nut side of the fork. Is that correct? The spindle is sliding into the fork too far with it on this way and I am wondering if the washer should be on the other side to prevent this? Don't want to take it apart again if I have it right. It is a bit of a trick working with two belts on four pulleys holding the fan and genny at the same time...alone. Appreciate any help!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.