Posted by John T on December 03, 2010 at 13:38:48 from (66.244.97.31):
In Reply to: How to Check a Coil? posted by Doug Kieta on December 03, 2010 at 11:19:55:
Lets answer your direct question first:
How do you check a coil to see if it is bad?
A simple Ohmmeter will tell you if a coil is BAD like a complete open or way out of spec LV primary or HV Secondary winding resistance BUT IT CANT TELL YOU ITS NECESSARILY "GOOD" because typical problems may not happen until it warms up and/or it may be high voltage insulation failure/breakdown which the quick low voltage ohm meter test wont detect.
A "real" coil tester does it better
"Typical" not all and the answer depends on the coil voltage etc:
LV primary winding between little + and - terminals may be in the 1 to 4 ohms range (say 1.5 to 3 ohms on many, depends if for 6 or 12 volt use)
HV Secondary may be in the 4,000 to 10,000 ohms range
IF EITHER IS OPEN ITS A BAD COIL although many coils will test good for the above but once warmed up she will suffer a HV insulation breakdown and fail to produce a spark
ANOTHER CAUSE OF SPARK FAILURE AFTER WARM UP IS A BAD CONDENSOR Check that first as its much cheaper to cure !!!!!!!!!!!!!!
Its easy to bench test a coil, you simply rig a circuit to pass current through its LV primary but then interrupt/stop that current flow and it should produce a HV spark out its top HV terminal/tower. You can rig plug wires or even a spark plug to do this easy simple bench test. NOTE if a good condensor is in paralell with the simulated points (where you close but then open the coils low to ground connection, i.e. what a set of points does closed then opened) theres a better spark mind you, she still fires with no condensor (unless coil bad) albeit weaker then if the right condensor were in the circuit
You can do it on the tractor with a plug and/or plug and wire and have the ignition on and points closed and uee an insulated stick to open the points and each time they open the coil should produce a spark. One can put a plug wire in top the coil and have other end to a side grounded spark plug and see if she fires. Or just pull plugs and/or wires and turn her on n crank her over to see if the coil fires and/or all the plug wires/plugs
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
