The starter relay on the starter motor is a small can with 3 or 4 terminals. There are two big, and one or two small studs. The small stud is close to one of the big studs. This might have an S stamped near it. This small terminal is the one that should be connected to the starter button. The big terminal close to it should be connected to the battery, and have a second #10 wire connected to it as well. The other big stud should be connected to the starter motor terminal.
If there are 4 terminals there will be one labeled S and another labeled I. If so ignore the I terminal, and make sure nothing is attached to it.
To begin, make sure the wires are as described.
Remove the S terminal wire.
Now (with it in Neutral, and the brake set, remove the ground strap from the tractor frame and put it so it cannot touch the frame (in a rubber glove is cool). (this prevents dangerous potential explosions of the battery) Now reattach the battery cables on the battery terminals. With the S terminal off, there should be no starting the tractor at all, but it should not spin. Touch the battery ground cable (from the glove) to the frame briefly. There should be no sparks and no starter action. this is good. If it does spin, you need a new relay. If it does not, next reattach the battery ground (clean and shiny). You will next touch the S terminal with a jumper from the big terminal where the bat cable attaches (a screw driver will do, they are an inch apart), the starter should spin. If it does, release the jump, (it should stop trying to start!. Next try the wire that was on the S terminal by touching it to the S terminal. If nothing happens GOOD. If it spins, the push button or wiring to it are wrong/bad. The push button should be momentary contact. If it is shorted inside, it will stay cranking (not good) replace the switch. The supply to the switch comes from the load side of the amp gauge. Let us know what is happening from this description and test sequence. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
