Farmall & IHC Tractors Discussion Board |
Re: Re: Blades for my belly mower Farmall cub 1951
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon on June 29, 2000 at 05:03:02 from (207.192.72.231):
In Reply to: Re: Blades for my belly mower Farmall cub 1951 posted by JLE on June 29, 2000 at 04:41:50:
I have no idea how to identify the manufacturer. The blades are 20 1/4 inch long and there are three. There are actually three holes but only two for mounting. The bolt holes appear to be 9/16 and the distance center to center is 4.5 inches. I beleive this is a woods deck 60"cut. The shape of the deck is straight along the front edge and triangular along the back. It has 5 sides. It also has 2 feet on either side sort of like catchers. Not sure if this helps. The front guard is missing so if this is where the ID plate is located then I am lost. I hope I gave you enough info. Thanks for replying. Jon
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|