Posted by Farmboy856 on November 19, 2010 at 20:07:12 from (74.215.181.71):
In Reply to: 12 volt conversion posted by Jim iowa on November 19, 2010 at 07:39:34:
One thing about locating the ballast resistor between the ign. switch and coil--- don't make the stupid mistake I made in haste on my M and bolt it to the bracket under the fuel tank. I was in a hurry and lookiing for an easy spot to put the thing, and there was an empty hole in a bracket under the fuel tank--- the primary wire from the switch to the coil ran right past it, so I thought, "wow, what a great place to put the resistor." Later on it dawned on me that this is directly below the filler neck on the tank, and if you overfilled or just spilled fuel while refueling, the spilled fuel would wind up directly on that possibly very hot resistor. I changed it immediately.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.