Posted by Tom Fleming on November 14, 2010 at 02:57:25 from (206.193.253.243):
In Reply to: IHC wrenchs and tools posted by todd heck on November 13, 2010 at 07:58:28:
I have been assembling tools for each of my letter series and F series tractors as listed in the Owner's manual. I will tell you that IHC or IH marked tools vary widely in price. I paid $80 for the E4A and F4 mag wrench with integral point and plug guage. Other tools, I have picked up very cheap at flea markets. End goal is to have a complete set of tools for each tractor.
I am pretty much in agreement with what other's have stated. condition is first criteria for price. If you are looking to sell, give the people on this site first crack at it, and make it fair. If the prices offered don't make you happy, then put it on eBay with a reserve of what you want for it. If you still don't get your price, then come back to the good folks here and meet in the middle.........if you do get your price on eBay, then smile and listen to the "cha-ching".....................................
A fair price amongst fellow collector's is always reasonably less than if you are selling straight out. Selling to "Joe Collector" on the open market will get you the highest price, but it may not sell as fast as you would like.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
