Hi Brett, the last 3 clutches that I installed in a 74/84 series tractor were re-manufactured clutches and pressure plates sold by CaseIH at a very competitive $$ and they had a core exchange as well. The most expensive part per pound was the clutch release bearing at $60. I always use the HD pressure plate and 6 pad clutches. You should check the flywheel and possibly have it ground to spec. If you have the flywheel off, re-torque the cap screws on the rear main crank seal. To remove the pilot bearing, I have a carriage bolt with a head that just fits through the shaft hole and the lip on the head catches enough of the bearing to extract it. Others on this forum have suggested that filling the cavity behind the bearing with grease and then driving a shaft into the grease will push the bearing out. On re-assembly, I place pressure plate and clutch on PTO and transmission shafts and put tractor almost back together but leaving enough of a gap that a long screw driver can be engaged in the ring gear and using one of the bolts in the casting as a pry point, I use the screw driver to rotate the engine to install the pressure plate bolts through the clutch inspection plate on the bottom of the bell housing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
