Posted by dpski on October 28, 2010 at 05:38:09 from (128.222.37.58):
Argghhh..... Please tell me it"s just air in the system and it will work it"s way out.
Finally pulled the starter rod on my Super C last night after months of work. It was a happy moment to hear it run again, except to my surprise the hydraulics are not working. This project started with a leaky radiator, months later and countless hours later of preparation, paint is dry and ready to put the wheels back on.
Of all the things I disassembled, fixed, and re-assembled, to many to list here, you guys know the deal, the hydraulics were the least of my worries upon startup, because all I did was disconnect the FastHitch hydraulic lines. Already rebuilt the hydro pump last fall with new O-rings 'cause it was leaking into the crankcase. Drained and refilled the whole system and cleaned the screen as well last fall. All was functioning just fine when I shut it off before this project started.
I topped off the hydraulic fluid, been using Case/IH Hy-Tran. I worked the levers, both the TouchControl and the remote FastHitch cylinder lever back and forth a bunch of times. Took the TouchControl hydro unit filler plug out during all this hoping to see some fluid movement and/or let any air in the hydro unit escape, nothing.
I greased all the TouchControl arms before painting because I didn"t want the paint to get in-between them and bind them up.
I"m at a loss for all I disconnected was the remote FastHitch lines and the rods from the TouchControl levers. The hydro unit, pump, and metal tubes to/from pump to hydro unit remained intact during all this.
I"ll try it again tonight and hope it"s air stuck in the system, but anything else I can try or check?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
