Farmall & IHC Tractors Discussion Board |
Re: Hey Wardner
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on June 20, 2000 at 15:17:48 from (63.23.216.124):
In Reply to: Hey Wardner posted by Pat on June 20, 2000 at 13:28:17:
Yep, I believe it is a Prince pump. They make two diferent sizes - one being a little thicker than the other. 12.8 GPM @ 2000 PSI at 540 RPM 23.0 GPM @ 2000 PSI at 540 RPM I am not familiar with the Farmhand F11B loader. However, you will need double-acting cylinders for two way power. In most cases that will mean a pressure port at the top and bottom. The IH 3x8 cylinders used on the fast hitch have both ports on the top but an external pipe runs to the bottom. You will also need a four way open center valve to direct hydraulic flow. If it has a float feature that would be even better. I like to buy fittings and hoses from the Surplus Center in Lincoln NE. Tel 800-488-3407 to get a catalog. Have fun.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|