Posted by JeffL on October 10, 2010 at 10:29:44 from (97.231.126.52):
I have a 350u with manual steering and front PTO pump (for loader) off the front of the crank (not the distributor gear style or belly style).
I bought the power steering parts from a 350u that had the belly style pump. Came from a junkyard and not sure it was working or not other than it did steer the tractor to move it around with no engine (bad block).
Anything I should do to test the power unit before I start? Anything I should replace as far as seals etc (I will use all new hoses for sure)? I was going to try testing it with air, then turn the steering shaft and see that the motor moves one way, then steer the other and see the motor move the other.
Not sure what pump to use:
I read other similar posts and found a 1965 ford mustang Eaton pump that i can buy working for $30. I can fab a bracket, i have a plasma cutter. Might just take off the generator and put the Eaton pump there to start with since the generator is not really keeping the battery charged anyway.
I saw a chrysler eaton pump with 6 volt delco generator combination for $100, but wasn't sure the eaton steering pump would be right though. It is two units with one pulley, that would bolt right up to the current generator bracket, i would probably have to use the guts from my 12V generator, and I don't know if they would be the same.
The other option would be to tee off the big pump, but as that one is used for loader and backhoe I am apprehensive about it. Also I would have to add some kind of valving for that I think, as I understand it the pressure regulation was down in the belly; and the Ford Eaton pump has it in there, and of course my big pump does not have that; relying on the control valve banks.
I looked at the power steering on my Super-M and see that there is an added front pump with a belt and it's own pulley. I thought maybe there was a way to add an extra pulley to my 350 and then leave the generator pulley separate.
I should mention that i use the thing to dig in tight places like my creekbed, and filling my 57 chevy 4 yard dump truck (yeah i still use it to haul stuff). it is never used for field duty, have other tractors for that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.