Posted by pete 23 on October 04, 2010 at 20:31:25 from (184.12.35.82):
In Reply to: To Pete 23 posted by Larry B 1486 on October 04, 2010 at 16:14:23:
Well, I would go for the easy stuff first. There is an o-ring under the primer pump bail, if I remember correctly you can put a small punch in hole plunger stem and screw off the knob to replace o-ring. Other wise, look very carefully for any sign of wetness at the pipes from primary pump to final fuel filter and at filter. Really, if you have a good head of fuel in tank, the pump head should not drain back but if pumping helped it is draining back. There are inlet and outlet check valves in the primary pump and seal on shaft but that would require removal of the primary pump. That can be done without removal of main pump but can get a little tricky with gov spring etc. Main plunger and head should not be contributing to problem. If you have an auxillery fuel tank below pump level that could be a source of the problem also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.