Farmall & IHC Tractors Discussion Board |
Re: Should I trade 706 Vs 340
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John W. on June 16, 2000 at 06:27:01 from (63.162.252.98):
In Reply to: Should I trade 706 Vs 340 posted by JC on June 14, 2000 at 15:55:51:
Richard is right, it depends on what you want to do. There is a huge difference in the capabilities of a 706 and a 340. If you want to make/handle round bales, pull a large rotary cutter (10'+), or pull a 12-15' wheel disk, or use a front end loader, the 706 is a good tractor for the money (hydraulic T/A and brakes, better hydraulics, 8F/4R transmission, etc.) If you want to pull a small cutter (5-7'), till small fields/gardens, or pull a square baler, the 340 is more than adequate. I have a 706D (which I like a lot), also have a 330 utility for the small stuff.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|