|
Farmall & IHC Tractors Discussion Board |
Re: H motor rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jakee on June 15, 2000 at 20:33:52 from (152.163.213.191):
In Reply to: H motor rebuild posted by tim on June 15, 2000 at 19:11:18:
find your self a super h or 300-350 block and run the 350 pistons with a very little bump on then . then find a 300-350 propane head,do a clean up cut of about .050 and you will end up with about 65-cc,s in the conbustion area,take your head to a real good head man and do a 3 angle valve job,also set up the sprins at about 85 on the seat and about 165 at full lift, advanse the cam i tooth,use the good head gasket from VICTOR set your total timing at about 34deegreze,you my try a little more but watch it for spark knock, then hand fit each individual ring about a inch down in the bore,wen you put the sleeves clean the bore in the block real good and try them they should drop down about 3/4 of the way if they dont hand hone the block till they do. then coat the sleeves with green lock tite it,s made for sleeves,the deck highth on the sleeves may run from 0 to .006 above,never below the deck.make sure you re-jet the carb,and match the intake and exhaust to the head, you will end up with around 65 hp. remember you will need good gas for this but if you keep good gas in it you could take it to the field and work it all day.good luck--a 65 hp H feel,s real good
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
