Posted by Wardner on September 11, 2010 at 20:26:11 from (4.154.239.7):
In Reply to: Update posted by Mike CA on September 11, 2010 at 16:05:50:
How many people in a squadron? Can't find the Table of Organization for such a unit on the Net. As a former US Marine, staffing levels are a key metric for any infantry unit regardless of echelon.
Anyway, I went to the Dublin Gas Engine Show today in New Hampshire. It's the biggest show in these parts. The guy with the 40 quart freezer (that's huge) was there and making "ice" cream. It was terrible. The mix was only cooled to about 28 degrees (my estimate) and was more like a frappe and very bland. Theoretical salt/ice can achieve 11 degrees. I think that optimum serving temp for scooping ice cream is around 23 degrees. He said he mixed and froze each batch for 45 minutes. Obviously not long enough or poor salt/ice ratio. Perhaps his little 1.5 hp engine didn't have enough power for a cooler (thicker) batch. The servers were "scooping" out of a domestic deep freezer and had about 15 gallons in reserve.
I bring this up because I don't think a couple of readily available and cheap 6 quart White Mountain Freezers will handle a squadron. I recently saw an original, and vary rare, 20 quart freezer go for $3400 on eBay. New 20 quarts are available for around $1000. They are made by the Amish in Ohio but I am having no luck locating the factory. I am fairly sure the dealer is marking them up at least 100%, perhaps 200%.It appears that he has an exclusive sales arrangement with the Amish.
I am building my ice cream tractor to handle approximately fifteen 20 qt freezers. That will be quite the spectacle to see them all running at once. I will switch to air motors for the last few degrees and run the motors until they stall. That should give me a consistent, well cooled product. Been thinking about building my own mixer/freezers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.