Farmall & IHC Tractors Discussion Board |
Re: Tuning Up 1947 H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RKS on June 15, 2000 at 09:15:56 from (199.174.128.168):
In Reply to: Tuning Up 1947 H posted by J R P 3 on June 13, 2000 at 11:06:27:
some small advice. unless you are very accomplished, don't rebuild the carb until after the ignition tune-up. when the tune-up is dead on, (nailed!) - then do the carb. the H carb is simplicity, if you clean it out well and replace all required parts. before mounting rebuilt carb, test it by filling float chamber to level *higher* than main venturi jet, see that gas rises throughout the low idle and main venturi shafts, and spills over the main jet - otherwise, the carb won't function correctly. the passage between the main needle valve assembly and the main shaft has a brass fitting. it must be cleaned out well. good luck, RKS
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|