That still doesn't answer the more important questions. Are you pulling in Division __, NATPA, county fair classes, antique classes or ??? Every pull has different rules that DRASTICALLY change what you can and can't do (and stay within the rules)
Division/NATPA Classes are very strict.
County fair/local pulls are generally run what you brung and hope you brought enough.
Antique clubs are generally strict, but not like the sanctioned classes.
I am not trying to be a dick, but your end goal is VERY important. There is no sense doing something that would get you kicked out of every pull. ie dropping a flat head Ford in an F-20. Very cool, but nobody will let you pull it. I have pictures I should post someday :D
If you want to build a motor there is a guy that used to frequent the board (be still may) that was pretty sharp. Don't remember his handle right now, but you will notice him when you see him. Go to the pulling section and look him up. You might as well not waste your time posting over there bc everybody is so tight lipped it is ridiculous. They are always afraid they will talk about the tip that will beat them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.