Farmall & IHC Tractors Discussion Board |
Re: Cub overhaul of one cylinder?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg Martin on June 14, 2000 at 17:04:42 from (216.128.162.191):
In Reply to: Cub overhaul of one cylinder? posted by brian on June 13, 2000 at 12:26:42:
I've done this several times, pull the plugs, find the fouled one, pull the pan and head, use a putty knife to remove the head, the gasket is a sandwich type gasket[ 3 pieces] pull the piston, the rings will probally be stuck to the piston,[ you should be able to look at the cylinder and see where the rings are collapsed by the wear on the cyl] ,go to a real auto\ truck supply, get a set of rings for 1 cyl, a tube of RTV sealer[ red or black] and a can of wheel bearing grease.. Remove the rings, break one of the old rings use it to remove all the carbon in the piston[ scrape till u see aluminum.. Stagger the ring gaps oil and install,, If the rod bearing is down to brass, I would replace all the rod brngs [4] with .003 oversize bearings.. Remove the lower plate of the oil pump, sand it on a flat surface and put a 1\4" nut in the bypass spring to add a little pump pressure.. I expect to hear some flack on this repair, but have been broke before but I was still riding. I did this on a 58 ford pu and drove it for 3 yrs. How about it ITF, got any thing to add?? Forgot about the head gasket., coat both sides with the grease, do not scrape the head or block, retorqe to specs with a grunt, run 2-3 hrs retorque....
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|