Farmall & IHC Tractors Discussion Board |
Re: Re: A whole can of Worms!! Maybe???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by p on June 14, 2000 at 13:42:03 from (12.33.190.5):
In Reply to: Re: A whole can of Worms!! Maybe??? posted by Regularman-lead additives are a scam! on June 14, 2000 at 08:21:35:
I have talked to engine builders who have witnessed the seats destroyed by this, but it is not that common but CAN happen. IT is not a scam. It is an insurance policy. The hardened seats prevent the seats from over heating and small amounts of metal sticking to the valves. This will slowly destroy the seat and valves with little pits in each. Also the lead lubricates the valves to prevent sticking in the guides. I do not know if the tolerances were tight and needed the lubrication or if it just helped but it can't hurt. With an older motor these are worn and sticking is unlikely. If you are running a flathead motor, i.e. cub or such, it is not as crucial since if a valve sticks it will not hit a piston. With an overhead valve motor you run a slightly higher risk since the piston could contact the valve IF it were to hit. I don't use the additive but used to when I ran these machines harder. Bottom line!!! IT CAN'T HURT
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|