First of all, Im not sure of your volt meters accuracy or the battery condition, BECAUSE a good batetry thats charged should read in the vicinity of 12.6 volts, unless theres a decent current draw which is dropping the voltage, of course.
Next, just where are you measuring that 13.2 volts on the Regulator, on its ARM/GEN terminal or the BAT terminal?????????? If the ARM/GEN terminal that may not be enough (depends on your meter accuracy and gennys output) to pull in and latch the VR's Cutout Relay in which the genny dont ever get coupled up to the battery (via closed cutout) to charge it and therey raise its voltage to the 13 and 14 volt levels. If that 13.2 is on the BAT terminal that should be enough to put at least some charge (pump current into) in the battery.
THE VOLTAGE THAT MATTERS IS ON THE BATTERY, it should read 12.6 setting but rise to the 13 and 14 levels if coupled to a good working genny. If the genny is actually only reading 13.2 volts open and unloaded (i.e. cutout relay is open unlatched) at fast RPM that dont sound quite high enough to me and the genny itslef may be bad or else theres a severe genny to VR mis match or the VR is bad or not well grounded
YOU NEED TO RUN PARA 5 OF MY TROUBLESHOOTING PROCEDURE which grounds the gennys FLD to see if non chargign is fault of genny or VR etc. be sure belt is good n tight also
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
