Posted by Janicholson on August 30, 2010 at 06:35:25 from (199.17.6.223):
In Reply to: Steeped head pistons posted by nickc711 on August 29, 2010 at 18:48:45:
THe pistons (if put in correctly and of the correct size for the bore, will work. The steps of the new pistons will give substantially higher compression. Which is also OK. if there is doubt about the pistons hitting valves, or the head, the head can be put on with an old gasket, with modeling clay (oil based) layerd on the piston "steps" about 1/8" thick. Turn the engine over by hand to be sure it does not bind. No point on the clay chould be less than .020" thick. Where problems are found are the edges of the step. (only one piston needs to be installed to do this check, and it is unlikely to be a problem. Just tighten the head bolts to 1/2 their normal torque, the gasket is already smashed. If the pistons clear everything, the worst case is to need to use mid grade or premium fuel if the compression is in the 160psi or greater range. Of course several manufacturers make different step sizes for different ratios. IH made them for altitude adjustment from the factory. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.