Farmall & IHC Tractors Discussion Board |
Re: Wire Type for Main Bearing Bolts
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarknOhio on June 12, 2000 at 20:04:12 from (207.90.95.72):
In Reply to: Wire Type for Main Bearing Bolts posted by cheg on June 12, 2000 at 19:27:17:
I don't know if it's the correct wire or not, but I used .041 aircraft stainless steel saftey wire on my '49 H. Check with the mechanics at your local airport. They should be able to either give/sell you enough to do the job or tell you where to get some. Normally it's sold in one pound spools. I'm not even sure if it's really necessary or not but I went ahead and saftied mine. Just make sure that whatever wire you do use that you saftey the bolts so that if the bolts try to loosten it tightens the wire. In other words, the wire should be pulling on the bolt head in a clockwise direction.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|