Posted by Wardner on August 23, 2010 at 15:12:42 from (4.154.237.164):
They pulled power off the top of the center section for the Electrall as shown.
On the bottom side of the center section, it is curious that the cover has nearly the same bolt pattern as a SAE 6-bolt PTO. One axis is off by 1/8" as shown by a truck PTO gasket laid over the tractor IPTO cover plate. It would be no problem to order truck PTOs with the altered holes. Someday I will probably re-drill a SAE PTO to do just that. A 4" gear or sprocket attached to the IPTO coupling has enough clearance inside the tractor center section. I can't see why the cavity is so large. It could have been made smaller and added strength to the center section.
This is what it might have looked like. The nice thing about SAE PTOs is that they are all shiftable and some have two speeds.
This my current solution. It was alot quicker than tearing apart the tractor and finding the right gear combos plus setting up the correct gear lash. It is Balanced Head Mower drive chain driven from the rear PTO that is routed underneath the left axle with a shaft.
So the question is: Did IH plan on attaching an off-the-shelf PTO under the tractor?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.