Posted by Tom Fleming on August 12, 2010 at 16:29:35 from (206.193.253.243):
In Reply to: M magneto trouble posted by William Ransom on August 11, 2010 at 14:18:39:
absolutely. you do NOT have to go to a CIH dealer to get wires, rotor, and cap.
Tractor supply has them, and so does NAPA (or at least can order them in)
My honest opinion is get copper core wires first. Clean up the contacts on the rotor and inside the dist cap. Don't throw good money after bad. If the wires are as you said they are, then they absolutely need to be replaced, and replaced with copper core wires. Heck, you can buy the parts at NAPA, and make your own wires. That's what I do. I bought a 50' roll of copper plug wire. Box of boots, and a box of connectors.
If you don't want to make your own, TSC (tractor supply co.) has sets pre-made.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.