Farmall & IHC Tractors Discussion Board |
Re: For Mike K
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike K on June 09, 2000 at 11:26:53 from (206.159.164.18):
In Reply to: For Mike K posted by Dean on June 09, 2000 at 09:59:06:
Dean,You are very welcome to any info I have. Not too long ago I was in the same spot you are, unfortunatly there was`nt an internet. I read your reply you received about H.P. actually it was the early cubs that were rated at 10 H.P.the brochure for the 184 rates it at 18 H.P.(go to the archives and do a search for "Cub Horsepower",lots of good stuff there). A post hole digger will have to be a IH for your tractor,you have a non-standard PTO the spline is 15/16"vs1&3/8" and the speed is 1800vs540 RPM. IH can sell you a CBI-4 parts manual that will show you all the implements ever made for these tractors(parts book for your tractor is TC-131)both are very helpful. I`m surprised about the loboy on the ID plate mine is a 79 or 80 and has no reference to loboy on the tractor or manuals.Yours might be a very early 184 not sure about that though...Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|