I don't know what you are seeing on the fuel adjustment screw, but unless someone has already modified it somehow, there is no difference between the distillate/kerosene carbs and the gasoline carb. There may be some difference in the main metering nozzle, but again, it may have already been modified. Some folks do try to improve the performance by drilling out those holes, but usually all that is accomplished is to create an over-rich condition. The exception to that would be IF the tractor has the M&W engine kit in it, and the carburetor has been rebuilt with the M&W high performance kit, then the holes in the metering nozzle ARE bigger. There is no point in rebuilding the carb with a kit for the 47387 carb since you most likely will be running it on gasoline anyhow, so use the kit for the 50983. It will fit your carb. Chances are good that is what is in there now.
There is a part number on the head, but it is under the valve cover. That number will tell you if you have the high compression gasoline head, or the low compression distillate/kerosene head.
The serial number of the tractor will have the suffix "X1" if it was originally a gasoline tractor, "X3" (I think) for kerosene, and no suffix for distillate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
