Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Need help finding seals for Farmall H cross shafts
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on June 07, 2000 at 08:10:49 from (206.246.187.2):
In Reply to: Re: Re: Need help finding seals for Farmall H cross shafts posted by Harry on June 07, 2000 at 07:34:59:
Harry I simply start tapping the first seal in all the way around with a hammer keeping the seal even as I tap. When it gets flush with the casting, I use a 3/8 inch or 1/2 inch socket extension and use the side that attaches to the rachet against the seal to tap it in further to make room for the second seal. The new seals are fairly thin so you will have ample room for both seals.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|