Posted by CNKS on July 22, 2010 at 18:15:50 from (216.144.104.128):
In Reply to: Painting Question posted by Wilks54 on July 22, 2010 at 12:07:59:
Two part means paint plus hardener. Two stage means base/clear. I have started using base/clear, but only because I have to sand and buff to get rid of the lint, etc that settles in my paint. (probably I am too picky) The clear in the base/clear system is much easier to buff than single stage, at least it is for me. Otherwise there is no real advantage. As to the sheet metal base/clear and the rest single stage, I have done that. There is little or no color difference, the toners (mixing) tints are the same, but they are not in the same ratio, so the possibility of a color difference does exist. The main difference is the stuff in the can that you add the toners to. A perfect color match is not guaranteed, but I have not had that problem so far.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.