Posted by ScottyHOMEy on July 21, 2010 at 17:18:47 from (64.222.223.144):
In Reply to: Farmall B width posted by bkpigs on July 21, 2010 at 12:59:11:
Specs would be from 64" - 92" , but that's only treadwidth between the centers of the tires, so if you added 9-1/2 inches for the customary 9.5x24 tire, 101" would be about right with it set out to its widest. Using the same numbers, it could be narrowed up to about 73".
As far as hauling it on your trailer goes, with everything set up for the narrowest treadwidth, edge-to-edge on the tires would consume about the approx 73". Only trick, but it shouldn't be a problem given the way they are tapered, is that when it's set up at that narrowest point, the wheels are dished out, so that overall width is even wider. But with the taper in them, they will clear the average wheel well and roll right on.
Narrowest treadwidth is with wheels mounted with the crown side of the dish facing outward, the offset lugs on the rim turned to the inside, and mounted to the inside of the wheels.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
