Well, I'm kinda speachless. You must find a cannister of malted milk & find out what all the fuss is about. If you can't find malted milk powder, find some Whoppers malted milk balls, throw about a heaped cup in a blender 3/4 full of vanilla ice cream & add about 1/2 cup of milk. You may need more milk to help your blender a bit. The malts I make are thicker than a slurry tank in January & mix about as well if you don't have a strong blender. Blend at low or medium until the "whirlpool" forms on the surface & turn it up to high for about 2 to 3 minutes, maybe a little longer if it's real thick. The run time on high is to aerate the mix. Even the thickest of malts & shakes must be aerated. My current malted creation is English toffee-coffee-carmel. It's almost perfected to the point of not stopping for brain-freeze & my sweet tooth 'bout died. I'd like to mail you some, but I can't keep it from running out of the envelope. ;v)
The 4 jerk fountan is a beaut! I can't wait to see it all fitted up to the S.A. W-400. Is the foutain fairly light or will you have to add power steering? The FH framing, weight box & other accoutrements must add a bit of weight too, I'd wager. I suppose you could balance it out with a wet bar on the other end of the tractor, for the adults. I know, I shouldn't be giving you more ideas. Sorry!
The iron bending log splitter is a great idea. Are those dies of some kind, on the ram? The wedge is curious too. It reminds me of the replaceable "edge" on the bucket of a loader or snowplow. Is the splitter run off of a tractor or it's own power unit? Looks like a good sturdy setup.
Well, I'm off to make a batch of brain freeze & go to bed. I have to fine tune my sickle bar, in the morning, so I can cut hay here when I have a dry window.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
