I agree that the lever should run paralell to the bottom of the floorboard, but it dosent It runs up to the bottom of the floorboard. Yes, I can get tension when it is unhooked from the pedal, but the pedal applys way more torque than what I can that, tho I think I have tension by moveing the lever by hand, when I attach it to the pedal, and apply a little tension/push on the pedal, it goes right and all the way down. I suspect that theres something to do with the square headed bolt at the bottom of the cover, tho I dont know what it is. I have I & Ts manual on it, and it says to tighten the bolt all the way tight, and then to loosen it 1/2 to 1 turn till all drag is gone. Whats drag, in something that isnt moveing? the band at the very bottom of the drum isnt moveing to create any drag, so thats got me all lost.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.