Posted by Farmergeist on July 01, 2010 at 18:22:18 from (75.68.208.102):
I have a really old Sickle grass cutter...an old John Deer from the 1950's or 60's. It was working fine. All of a sudden, the wooden Pitman arm broke off near the ball "clamp", for want of a better word.
Put a new one on, but it kept popping off the ball on the blade. Was told to lubricate it more, that the blade was working too hard. Good advice, did as told, was running fine...for about five minutes, then the new wooden pitman arm broke--literally sheered off before the ball clamp.
I can't figure out what is wrong. It has been working fine for years. It appears the clamp pops off the ball and the arm then self destroys.
Any suggestions from you experienced older farmers out there....besides buying another cutter?
But, by the way, if you did buy a new cutter, what brand would you suggest for a Farmall H which connects to it via a PTO.
I hate to get rid of the old one and want to fix it, but this sudden propensity to self destroy is getting to be a pain. HELP!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
