The pin is tapered and can be wedged in pretty tight. I have had success putting a 7/16" hex nut over the large end of the pin and pressing it out with a 5" C-clamp. Pounding on the threaded end of the pin is a risky proposition.
The driver just turns the impeller shaft. The springs under the driver hold the impeller against the pump housing so it can move the coolant more effectively. The fan hub itself runs on 2 separate bearings which from a practical standpoint will last a whole lot longer than a bushing.
When you have the hub off the housing, there is a pin holding the pulleys on the hub. Look for it at the transition between the two grooves on the non-adjustable part. The pin is short enough to be driven in from the outside. Once the pin is out, press the grooved part off and replace the collar. If the bearings are the originals, consider replacing them at this time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
