Posted by Tom in Iowa City on June 22, 2010 at 09:47:32 from (173.21.35.134):
I have a friend with a 1927 McCormick-Deering 10-20 for whom I am posting this. His 10-20 is a 1927 with an Ensign carb. He has had a man working on it for a long time...mostly procrastinating. My friend tells me that his man has finished rebuilding it, BUT... the man claims that he will need a set of gaskets, where gaskets were not supposed to go...in other words, between where brass surfaces interface, where they never had gaskets. I don't know if he is right in this thinking. He's apparently afraid that it will leak if he doesn't use gaskets. As an alternative, he suggested that my friend maybe get a different carb. The man said he would not make the gaskets. Heck, I've made plenty for carbs and other things. Why not slightly oil or WD-40 the surface and then press it to the gasket material and thereby get a perfect outline? I've used that method with success. The man working on the carb says he found someone who would make the "seven" gaskets for 200 bucks...rediculous! What's going on here? Anyone knowledgeable about the 10-20 carb, please give me some advice. Thanks, Tom
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.