Farmall & IHC Tractors Discussion Board |
Re: Re: Re: F-20 serial number location
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill B on June 01, 2000 at 17:27:05 from (209.182.69.65):
In Reply to: Re: Re: F-20 serial number location posted by DICK BOWMAN on May 31, 2000 at 09:54:38:
There were several road gear setups. One of my F20s has a road gear built in to the transmission. Heisler (sp?) made a unit that attached to the front of the transmission, externally, and when I was a kid, the F20 i used had a Montgomery Ward road gear on front of the transmission, and it also had Sears foot brakes. The road gear that goes on front connects the input shaft directly to the output shaft by way of the shaft where the bearing is below the input shaft. To use it, we had to have the transmission in neutral, then shift the road gear into action. To have them both engaged at the same time would lock up the gears. I hope that made sense to you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|