Posted by riverbend on June 16, 2010 at 16:15:29 from (70.101.159.133):
The story (questions come later): I went to use my H yesterday and the battery was dead (4.5V). The tractor had been standing for a week.
This tractor has a 6V generator, voltage regulator system. After charging the battery all the cells were 1.225 - 1.250 s.g., 6.3 volts.
After running it all day today the battery is at 6.4V. The ammeter usually showed about +5 amps.
Trying to find the problem I disconnected the negative battery cable and measured the voltage between the neg. battery terminal and the cable. It was 2.8-3.0V. I was kind of hoping for zero.
Disconnected everything from the ammeter and still had 0.7V. Replaced the wire between the ammeter and the VR (and reconnected all the wires to the ammeter)and the reading dropped to 1.7V. Current measures 0.4 microamps (I'm not sure this meter is that good).
So to the questions: 1) Shouldn't the voltage between the neg. terminal and the cable be zero with the ignition and lights off ? 2) What do you think is causing the draw ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.