Posted by P and R Pete on March 12, 2009 at 07:40:32 from (173.86.4.206):
In Reply to: Clutch Adjusting... posted by eric skokan on March 11, 2009 at 22:02:49:
Eric, here's the premise as Scotty described, and indeed my fork was bent forward about this much on my SA.
Where do you hear that "grinding noise" coming from?
That fork is supposed to be straight up and down. In a worse-case scenario, bent forward even more, that bottom front tip of the 'handle' of the fork, that part that moves forward when the pedal is depressed, could be hitting the spinning pressure plate assembly, causing the 'grinding' noise in the bell housing.
AND thus necessarily pulling even MORE of the clutch rod forward to make the adjustment.
If you got someone on the tractor to push the clutch pedal down, (motor off) and THEN you stuck your hand in the hand-hole, (so your fingers don't get mashed), you may be able to feel if the bottom of the fork is hitting the pressure plate.
That fork is not the most solid piece of metal, and I could see how it would get bent if, once the throwout bearing was bottomed on the clutch fingers, a previous owner with a heavy foot had tried to press it down even harder.
This post was edited by P and R Pete at 07:49:47 03/12/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.