Posted by DonO-MN on June 10, 2010 at 15:04:26 from (144.15.255.227):
I am presently restoring a farmall 350 Diesel. After rebuilding the engine, I tried to install the flywheel last night. The flywheel is attached to the crankshaft flange with six 3/8" fine thread bolts. I got all six bolts started by hand, but when I started to draw up the last 1/2" or so, one of the bolts started to seize up like it was stripping out. I pulled the flywheel back off and that bolt was mangled pretty bad, but (thankfully) the crankshaft threads were still okay. I started to examine the flywheel more closely. Turns out the six bolt holes that I thought were evenly spaced around the bolt circle, are not evenly spaced. Five hole have the same spacing, but one of the holes is shifted 0.10" closer to the hole on its left, than the hole on its right. I checked the crankshaft, same thing. So I had a 1 in 6 chance of getting it correct the first time! My question is this, was this offset done on purpose to make sure the flywheel could only be put on in one way, or is the offset bolt a machining accident? Assuming it was done on purpose, why? Was the crankshaft and flywheel balanced together before being separated for assembly? I did find a sorta dashed line going to the offset bolt hole marked on the engine side of the flywheel (which is not visable to you when you are installing the flywheel) but no markings on the crankshaft. If Continental purposely intended to have an identifier to align the flywheel, wouldn't you think they would do something more obvious that a 0.10" offset on one bolt? Has anyone else experienced something similar?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
