Posted by jackdonkey on June 04, 2010 at 17:46:20 from (71.164.179.172):
In Reply to: ih 574 pto question posted by jackdonkey on June 02, 2010 at 14:45:13:
Jim
gaskets and orings were good,the flow channels are in the casting and looked good and clean,blew out everything with air,I thought the same about the ps relief valve,when I had the mcv off I took it apart and made sure the spring was not broken and the poppet was seating good inside of the valve.then i thought well even if it is stuck open then it should have flow right?the ps check valve, i checked it and and tried to install it another way and it would only go one way,the elbow fitting for the ps return line at the mcv has the check ball in it,I'm gueesing to allow fluid to return to the mcv but once the engine is cut off it won't allow it to return and bleed off like you said.I'm wondering if the pump is weak and pumps good free flow, but the book is saying it should pump 12gpm restricted to 1200 or 1600psi.and my meter doesn't allow me to restrict.I would think that steering and braking would take priority over hydraulics so the flow divider would work the steering and braking if pressure was to low.but I haven't messed with tractors to much.The other thing is the pto was working good,hooked it to a shredder and it turned it no problem.now its not working but it did when i had the hitch pressure hooked to the steering line but it felt weak as it would turn but I could hold it with my hand.I know it has me scratching my head
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
