Posted by karl f on June 02, 2010 at 12:39:42 from (209.188.106.159):
I completed converting our 400 to 12v w/ alternator. Had new brackets fabricated so it fits under the hood and uses the original belt.
The first alternator was a used freebie. would not charge. It had worked on the bench tester prior to my project but it did get rained on on accident.
the second alternator is store purchased but will not begin to charge until 3 notches from wide open on the throttle (around 1000 rpm). Even if you try to excite it with a jumper wire. once excited, it charges at all engine speeds.
I've double checked my wiring and it's correct. I thought the sealed warning lamp (not LED) was the culprit but the lack of excitement with a jumper wire seems to elminate that possibility. It's acting like a one wire!
The only other factor i can think of is the pulley size/alternator rpm. I am using a bigger pulley than a car. but it is smaller than the original adjustable generator pulley. i'll have to measure.
I assumed with the warning light setup that the alternator would become excited when energized regardless of rpm. Anyone else run into this before?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.