Posted by Dean Olson on June 01, 2010 at 13:33:09 from (76.203.158.151):
In Reply to: Farmall H, 4th Gear posted by Chief47834 on May 31, 2010 at 18:14:32:
The shift forks should be straight and evenly spaced when in nuetral. Your shifter tip may also need to be welded up. The bearing that holds that assembly may be worn and allowed the whole assembley to drop down just enough that the fork is not engaging. Grab the assembly and lift up on it. It shouldn't move much.This was the problem in an M I had that was doing the same thing your's is doing. I ended up bending the fork so it would work and ran it till the motor spun a bearing. If that doesn't work I would guess that the gears aren't installed correctly. I can't imagine how that could be but I'm no expert. Post a picture of the gear train looking down from the top and the true experts on this board can tell you if it's correctly assembled.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.