Farmall & IHC Tractors Discussion Board |
39 A clutch rod?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lynn on May 30, 2000 at 06:18:39 from (148.144.81.9):
Another silly question. We just finished replacing the cluth, pressure plate, throw-out bearing on my 39-A. We also had the fly-wheel turned down minutely. Upon restoring her, the clutch rod is at maximum adjustment with no threads left. Clutch works pretty well with about a 2-3 second "spin-down" before stopping. It's also a little noisy. My mechanic thinks that the clutch rod is a little too short because the fly wheel was turned down (he thinks it was turned down before in years past) His suggestion is to weld an extention onto the rod. I would have thought the rod would have had adequate adjustment for maintenance of this type. Any one have similar situation? Your suggestions are greatly appreciated. - Lynn
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|